| A2 |
The error code in the message means that there is an error code with regard to the PLC. |
| |
|
| |
<In a case where the error occurs immediately after MONITOUCH has entered RUN status:> |
| |
An area for the event timer macro, buffering area, etc. commonly used on every screen may be a cause of the error. |
| |
|
| |
<In a case where the error persists on the same screen:> |
| |
Any setting made on the screen may be the cause of the error. |
| |
|
| |
|
| |
|
| |
|
The display of the error differs as shown below, depending on the option checked under [Comm. Error Handling] ([System Setting] ->[Comm. Parameter] -> [Detail]). |
| |
|
|
| |
|
[Comm. Error Handling]: [Stop]
|
| |
|
 |
| |
|
| |
|
[Comm. Error Handling]: [Continuous]
|
| |
|
 |
| |
List of error codes |
